Thursday, August 4, 2016
Mirror Dinghy progress on our CNC kit assembly
I spoke to Peter the boat builder yesterday, progress sounds good and I will see him later today, so pictures of the Mirror Dinghy build then.
I think he has been fastening the pine cleats to the bulkheads and seats?
This was just one week back, the hull panels were put together two days later!
It was easy says Peter.
At this stage the copper wire has been removed after the epoxy paste fitted into the hulls ply joints was cured, this leaves a nice clean surface on which the glass tape will be epoxy fitted later.
Check the pine cleats which are fitted first.
Kits and part or fully built Mirror Dinghy's to order.
Roy
I think he has been fastening the pine cleats to the bulkheads and seats?
This was just one week back, the hull panels were put together two days later!
It was easy says Peter.
At this stage the copper wire has been removed after the epoxy paste fitted into the hulls ply joints was cured, this leaves a nice clean surface on which the glass tape will be epoxy fitted later.
Check the pine cleats which are fitted first.
Kits and part or fully built Mirror Dinghy's to order.
Roy
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment